Micro stepping motor driver PMD006



        Technical data

       General
PMD006pulse series
Suitable for upper computer:
PLC Single chip microcomputer Pulse controller
Support motor
Stepper motor
The power supply voltage:
DC 9-47.5V
Output current:
DC 0.4-6A
Microstepping:
0/128adjustable
Temperature:
-20℃-80℃
Maximum pulse frequency:
250K
The durability of:
Over 20,000 hours

        The interface definition
Interface
PMD006Pulse series
J1
ENA+-:Enable signal, optocoupler input, not enable on conduction
PUL+-:Pulse signal, optocoupler input
DIR+-:Direction (or pulse) signal, optocoupler input
The interface voltage:5V
J2
M10,M11:Step motor A phase
M20,stepper motor B phase
J3
VCC:Positive pole of dc power supply
GND:Direct current source

        Size

       Signal port connection mode
Connection
Wiring diagram (when the output voltage of the controller is within 5V, the resistance R can be omitted)
A total of Yin connection
This connection current flows in from the driver's + port, out from the signal-port, and into the controller's ground
Yang connection
This connection is suitable for connecting controller collector open circuit output
The differential connection
This kind of connection method is suitable for long line connection in harsh environment, and can significantly improve the signal transmission distance and anti-interference ability

        Download
CAD
.DWG
The 3 d file
.STP
The user manual
Debug software
None
Development of the document
None
Certificate

        Inbred selection guide

       Functional features
Function
Describe
Maximum 128 subdivision
Maximum support 128 adjustable subdivision, external dial code control
Standby dynamic control holding torque
Vertical installation in motor, screw transmission, standby when ordinary drive will not remain torque, dynamic control, load down potential problems PMD006 series drives can through the conduction of light coupling, let drive even standby exit mode, let keep the torque control, in order to prevent the load down, if don't have this function can let light coupling PUL + - not when in standby conduction
External adjustment of working/idle current
The driver supports the external knob mode to adjust the working current and idle current