Wiring and debugging of stepper motor driver

1、Stepper motor driver wiring

Complete the wiring of stepping motor driver as shown in the following figure in the power-off state. Note that all terminal connections must be carried out in the power-off state and live plug-in and unplug are not allowed.

<h6>Wiring and debugging of stepper motor driver</h6>

PMC006 stepping motor driver uses Japanese HRS 20P precision small pitch connector. Proper angle and force must be used when plugging and unplugging the stepping motor driver wiring. Incorrect plugging and unplugging angle will lead to terminal bending and deformation. As shown in the following figure:

<h6>Wiring and debugging of stepper motor driver</h6>

2、Stepping Motor Driver Debugging Software Operation Steps

2.1 Turn on the PUSIDebugTool debugging tool software after power-on:

<h6>Wiring and debugging of stepper motor driver</h6>

2.2 PMC006B4 Stepping Motor Driver Serial Port Setting

<h6>Wiring and debugging of stepper motor driver</h6>

2.3 Enter PMC006B4 Stepping Motor Driver Debugging Interface

<h6>Wiring and debugging of stepper motor driver</h6>

2.4 PMC006B4 Stepping Motor Driver Parameter Setting Procedure

<h6>Wiring and debugging of stepper motor driver</h6>

3、PMC006 B4 Stepper Motor Driver Recommended Settings for Each Parameter

<h6>Wiring and debugging of stepper motor driver</h6>

Note: After writing all parameters, all parameters can be read again to verify whether the parameters are written.

✕

Login


Lost your password?

Create an account?